Putting Brick on Flashing Syracuse NY

Many architects in Syracuse recommend that no mortar be used for the brick course that is directly on the flashing over a shelf angle. If mortar is not used on the flashing, what keeps the brick from sliding off the angle?

Hess Corporation
(315) 234-5330
100 Clinton Sq.
Syracuse, NY
 
Energy Savers, Inc.
(315) 437-3008
203B Bagg St.
East Syracuse, NY
 
MJ Richardson Contracting
(315) 472-1085
123 Richards Rd
Camillus, NY
 
New Heritage Woodworking
(315) 677-3884
7022 Bush Road
Jamesville, NY
 
Nu-Crete
(315) 720-6599
P.O. Box 145
Baldwinsville, NY
 
Capital Home Improvements
(315) 565-5401
914A Old Liverpool Road
Liverpool, NY
Services
roofing, masonry, chimney repair, windows, sunrooms

Ryan Heneka's Decorative Concrete
(315) 506-0336
105 Melvin Avenue
Liverpool, NY
 
Expert Chimney Services, Inc
(315) 469-5004
4800 McDonald Rd
Syracuse, NY
 
Brian King Contracting
(315) 263-3577
21 Lock St
Baldwinsville, NY
 
J.P. Megnin General Contracting
(315) 391-1383
938 Cty Rt 11
West Monroe, NY
 

Putting Brick on Flashing

Provided By:

Source: MASONRY CONSTRUCTION MAGAZINE
Publication date: May 1, 2005

Many architects recommend that no mortar be used for the brick course that is directly on the flashing over a shelf angle. If mortar is not used on the flashing, what keeps the brick from sliding off the angle?

When mortar is placed on flashings on foundations, it is normally used to level the lowest course. Even if the flashing is bonded to the shelf angle, the mortar does not bond well to either plastic or metal flashing.

After the masonry wall is installed and the mortar cured, the wall above the shelf angle acts as one rigid element. Because the exterior wythe is anchored to the backup with many ties, the wall is prevented from moving laterally. The shelf angle is not intended to provide lateral support, but instead its purpose is to create vertical support. The first tie is generally located at a height above the shelf angle equal to half the typical tie spacing. This placement provides sufficient lateral restraint at the lower portion of the wall.

Some friction occurs between the brick and flashing; however, this action is generally not relied on to provide resistance for lateral loads. As long as the shelf angle supports at least two-thirds of the wall width, the wall should be stable during construction as well.

I typically do not recommend using mortar on the top surface of the flashing since it slows down drainage of water from the wall.

Click here to read full article from Masonry Construction